![]() |
![]() |
![]() |
|
General Discussion (Everything Else) Discuss anything that doesn't belong in any other forums here. |
![]() |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
![]() Are there any issues I might face if I just plug it? Any advice is helpful. Thank You... Rev
__________________
Pimp'n Da Reds |
#2
|
||||
|
||||
![]()
Rev, if you plug the intake.....I don't see any problems, other than the pump running when turned on.
![]() |
#3
|
||||
|
||||
![]()
if you dont want to plug it up just take the hot wire off the switch going out to the pump motor. ive never heard the fuse being pulled off and the entire row goes out. you should have a fuse for each circuit. if one fuse went out and they all went off then whats the point? you could always cut the wire at the pump. they make rubber plugs that fit into those holes also.
|
![]() |
Bookmarks |
|
|