Speck Calls

[C-Bass2mouth]

Originally Posted by speck-addict

in comparison to how much air it takes, which one you find takes less your RCC or Xciter?

I can get quiet with the Xciter with less air and it still roll over as compared to the RCC. But as far as running it on the higher end they both take about the same amount of air, with the RCC getting more volume. Seems like the xciter has more built in back pressure, so a lot of the growls and mur-murs I was used to doing on the RCC would break over in the xciter if you know what I'm trying to say. Basically I could put a lot of air into a growl with the RCC and it still just buzz the reed and sound like a growl. With the same amount of air and voice through the xciter it trys to roll over.

[bmatte8]

Originally Posted by C-Bass2mouth

I can get quiet with the Xciter with less air and it still roll over as compared to the RCC. But as far as running it on the higher end they both take about the same amount of air, with the RCC getting more volume. Seems like the xciter has more built in back pressure, so a lot of the growls and mur-murs I was used to doing on the RCC would break over in the xciter if you know what I'm trying to say. Basically I could put a lot of air into a growl with the RCC and it still just buzz the reed and sound like a growl. With the same amount of air and voice through the xciter it trys to roll over.

this is a really good break down of the two.

[redleg one]

Originally Posted by C-Bass2mouth

I can get quiet with the Xciter with less air and it still roll over as compared to the RCC. But as far as running it on the higher end they both take about the same amount of air, with the RCC getting more volume. Seems like the xciter has more built in back pressure, so a lot of the growls and mur-murs I was used to doing on the RCC would break over in the xciter if you know what I'm trying to say. Basically I could put a lot of air into a growl with the RCC and it still just buzz the reed and sound like a growl. With the same amount of air and voice through the xciter it trys to roll over.

There is more built in back pressure in the xciter,thus why it wants to jump out of murmur. Same effect would be seen on the RCC if you put too closed of a hand grip on the low end. However,the RCC is gonna be looser to run on the low end because of less built in back pressure.


Redbones and Ricelands dump more air or they are more free flowing as opposed to a call that has more built in backpressure


upside to increased built in backpressure===maximum efficientcy,and takes less fuel to run


downside,if you blow hard,must hold back or will force into overblow or out of scratch (murmur) quick---makes it less user friendly on the low because already backpressured inside the call,add hands on top of that and it wants to jump out of voice

[redleg one]

Takes a pretty good trick to have a call that runs loose low end,holds together on the high effort,and has a low threshold to start


most calls are toward one end or the other---nice high,efficient,holds distinction,good volume---BUT lacks in the low,way too tight,does not want to stay in murmur


then the opposite---stays in the mudd---runs a hell of a low,but falls completely apart in the high end,smears out and sounds overblown


and once a man can run low end and high end,it is blatently apparent when a call is lacking on one end or the other

[bmatte8]

Originally Posted by redleg one

Takes a pretty good trick to have a call that runs loose low end,holds together on the high effort,and has a low threshold to start


most calls are toward one end or the other---nice high,efficient,holds distinction,good volume---BUT lacks in the low,way too tight,does not want to stay in murmur


then the opposite---stays in the mudd---runs a hell of a low,but falls completely apart in the high end,smears out and sounds overblown


and once a man can run low end and high end,it is blatently apparent when a call is lacking on one end or the other

agreed

[AubreyLaHaye458]

Originally Posted by C-Bass2mouth

I can get quiet with the Xciter with less air and it still roll over as compared to the RCC. But as far as running it on the higher end they both take about the same amount of air, with the RCC getting more volume. Seems like the xciter has more built in back pressure, so a lot of the growls and mur-murs I was used to doing on the RCC would break over in the xciter if you know what I'm trying to say. Basically I could put a lot of air into a growl with the RCC and it still just buzz the reed and sound like a growl. With the same amount of air and voice through the xciter it trys to roll over.

Totally 100% accurate on the bartender. Put into words what I'm been trying to explain to my buddies


Sent from my iPhone using Tapatalk

[C-Bass2mouth]

Originally Posted by AubreyLaHaye458

Totally 100% accurate on the bartender. Put into words what I'm been trying to explain to my buddies


Sent from my iPhone using Tapatalk

I'd post a sound file, but I don't want to be the next B-Gizzle.. lol

[AubreyLaHaye458]

Originally Posted by C-Bass2mouth

I'd post a sound file, but I don't want to be the next B-Gizzle.. lol

Bounce the cluck bruh


Sent from my iPhone using Tapatalk

[redleg one]

how do you get a file on here?


make file,save on computer,upload as attachment?

[C-Bass2mouth]

Originally Posted by redleg one

how do you get a file on here?


make file,save on computer,upload as attachment?

I would think so. Or if you have a link to the file just copy and paste the link.