|
|
|
|
|||||||
| General Discussion (Everything Else) Discuss anything that doesn't belong in any other forums here. |
|
|
Thread Tools | Display Modes |
|
#1
12-17-2009, 10:06 PM
|
||||
|
||||
Changing go-devil bearing
i went run my go-devil today and while i was running the seal on the upper end of the shaft (near the motor) caught on fire. I removed the the shaft. Now how do i replace lower and upper seal? Is there anything i need to know on replacing these? The shaft had no scarring on it. any info would help thanks. bearings i meant seals.
Last edited by cordgrass; 12-17-2009 at 10:58 PM. 
|
| Bookmarks |
|
|
Threaded Mode